Ezen a weboldalon sütiket (cookie) használunk annak érdekében, hogy javíthassuk a felhasználói élményt és jobb szolgáltatást nyújthassunk. További információ Rendben!
Menü

KBS36051X

Ár:
45.989 Ft
Gyártó: Kelly Controller
Szállítási díj: 2.944 Ft
Átlagos értékelés: Nem értékelt
Elérhetőség: Nincs raktáron, érdeklődjön!
Kapható választék:
Stick Shift Throttle Firmware:
High Speed Motor Option:
Optional Waterproof:
Jelölje be azokat a kiegészítő termékeket, amiket még a kosárba szeretne tenni!
Kelly Programming Cable Kelly Controller Programming Cable
12.900 Ft
Csatlakozó Kelly 6pin vízálló Csatlakozó Kelly 6pin vízálló
2.990 Ft
Single Controller Control Box (KBS) Single Controller Control Box (KBS)
24.713 Ft
Csatlakozó Kelly 9pin vízálló Csatlakozó Kelly 9pin vízálló
2.990 Ft
Menny.:db

Leírás és Paraméterek

KBS BLDC MOTOR SPEED CONTROLLER

Kelly KBS  programmable BLDC motor controller  provides efficient, smooth and quiet controls for electric motorcycles, golf carts, go-carts, as well as industry motors speed or torque control.  Motor speed controller  uses high power MOSFET, PWM to achieve efficiency 99% in most cases. Powerful microprocessor brings in comprehensive and precise control to BLDC motor controllers. This  programmable brushless motor controller  also allows users to set parameters, conduct tests, and obtain diagnostic information quickly and easily.

Features:  
• Intelligence with powerful microprocessor. 
• Synchronous rectification, ultra low drop, fast PWM to achieve very high efficiency. 
• Electronic reversing.
• Voltage monitoring on 3 motor phases, bus, and power supply.
• Voltage monitoring on voltage source 12V and 5V.
• Current sense on all 3 motor phases.
• Current control loop.
• Hardware over current protection.
• Hardware over voltage protection.
• Configurable limit for motor current and battery current.
• Support torque mode, speed mode, and balanced mode operation.
• Low EMC.
• LED fault code.
• Battery protection: current cutback, warning and shutdown at configurable high and low battery voltage. 
• Rugged aluminum housing for maximum heat dissipation and harsh environment. 
• Rugged high current terminals, and rugged aviation connectors for small signal.
• Thermal protection: current cut back, warning and shutdown on high temperature. 
• Configurable 60 degree or 120 degree hall position sensors.
• Support motors with any number of poles.
• Up to 40,000 electric RPM standard. Optional high speed 70,000 ERPM. (Electric RPM = mechanical RPM * motor pole pairs).
• Support three modes of regenerative braking: brake switch regen, release throttle regen, 0-5V analog signal variable regen.
• Configurable high pedal protection: the controller will not work if high throttle is detected at power on. 
• Current multiplication: Take less current from battery, output more current to motor.
• Easy installation: 3-wire potentiometer will work. 
• Standard PC/Laptop computer to do programming. No special tools needed.
• User program provided. Easy to use. No cost to customers.

General Specifications:
•Frequency of Operation: 16.6kHz.
•Standby Battery Current: < 0.5mA.
•5V Sensor Supply Current: 40mA.
•Controller supply voltage range, PWR, 18V to 90V.
•Supply Current, PWR, 30mA Typical.
•Configurable battery voltage range, B+. Max operating range: 18V to 45V.
•Analog Brake and Throttle Input: 0-5 Volts. Can use 3-wire pot to produce 0-5V signal.
•Reverse Alarm, Meter: <200mA. Main Contactor Coil Driver<2A.
•Full Power Operating Temperature Range: 0℃ to 70℃ (MOSFET temperature).
•Operating Temperature Range: -40℃ to 100℃, (MOSFET temperature).
•Motor Current Limit, 10 seconds boost: 60A.
•Motor Current Limit, continuous: 25A.
•Max Battery Current :Configurable.

Max áram (10 másodpercre) 60A
Folyamtos áram 25A
Visszatöltés Igen
Feszültség 24-36V

Csatolt dokumentumok

Vélemények

Erről a termékről még nem érkezett vélemény.
Írja meg véleményét!

Akik ezt a terméket megvették, ezeket vették még meg:

385.238 Ft 236.889 Ft
146.039 Ft 114.989 Ft
106.938 Ft 98.888 Ft
126.489 Ft 98.888 Ft